Mil-Spec
Showing 109–120 of 461 resultsSorted by popularity
-
This A-A-3164 description covers a lusterless (flat) and semigloss synthetic resin lacquer for application onto lacquer resistant primer or recoating prepared metal surfaces. Not for use on bare metal without a primer undercoat. Provides a rapid tack free and dry hard condition at temperatures lower than curing type resins.
-
This O-A-51 specification covers one technical grade of acetone. This specification is canceled. Superseded by ASTM-D-329.
-
This A-A-3003 description covers two types and classes of low vac, spray applied, clear and pigmented lacquer intended for interior use on properly prepared metal and plastic surfaces, and sealed wood surfaces.
-
This MIL-R-81294 specification covers the requirements for four types and two classes of paint remover for epoxy, polyurethane, and polysulfide paint systems. Get a free quote on this polyurethane and epoxy paint stripper now.
-
AMS-3265 covers a polysulfide (T) rubber sealing compound with nonchromated corrosion inhibitors supplied as a two-component system which cures at room temperature. The polysulfide sealant has been used typically for faying surface sealing and for wet-installation of fasteners in aircraft structural joints, but usage is not limited to such applications. It can be used in non-fuel areas for fillet sealing and overcoating fasteners, for sealing joints and seams, cabin pressure sealing, and aerodynamic smoothing. AMS 3100 adhesion promoter can be applied prior to application of the sealant. This material is usable for continuous service from -65 to 248 degrees F (-55 to 120 degrees C), with short-term exposure (approximately 6 hours to 360 degrees F (182 degrees C).
-
This specification covers a pneumatic system grease. This grease is identified by NATO Code Number G 392. This specification is canceled. Superseded by SAE-AMS-G-4343.
-
The ASTM-D5363 specification covers an anaerobic single-component adhesive
-
This A-A-59295 CID covers solvent dispersed corrosion preventive compound referred to herein as “compound” for spray, brush, or dip application on new and fielded motor vehicles and trailers.
-
This MIL-E-463 specification covers the requirements for four grades of ethyl alcohol intended for Ordnance use. This specification is canceled. Superseded by A-A-59342.
-
This MMM-A-121 synthetic rubber adhesive specification covers adhesives for bonding vulcanized synthetic rubber gaskets, matting, and similar items to steel.
-
MIL-DTL-450 covers an bituminous asphalt compound for coating the surfaces of ammunition cavities prior to filling with explosives. It provides for an additional composition of material suitable for use in areas with specific air pollution regulations.
-
This A-A-50574 commercial item description (CID) covers odorless, alkyd, interior semigloss enamel, non-lead, in whites and tints.