MIL-C-83286B POLYURETHANE Coating is a two component chemically cured product that forms a film that is resistant to chemicals, solvents and abrasion. This product has excellent adhesion to most substrates and is recommended for heavy duty industrial applications where a tough, chemical resistant coating is required. This coating is available in a 1:1 mixture for brush, roll and spray applications. It is specially formulated for excellent ultraviolet ray resistance and superior exterior durability.
Surface to be coated must be clean, structurally sound and free of all foreign contaminants including dirt, wax, loose paint or grease. Greasy or oily surfaces should be solvent cleaned with care taken not to paint over moist or wet surfaces. The recommended primer is MIL-P-23377F Type I Epoxy Polyamide. The use of alkyd based primers under this coating is not advisable. Old paint in peeling condition must be removed. Sandblasting or wire brushing are the preferred methods. Chalky paint must also be wire brushed for maximum adhesion.
MIL-C-83286B POLYURETHANE Coating can be brushed rolled or sprayed. Mechanically mix each component, then combine at a ratio of 1:1 by volume. Let admixed material stand for 15 to 30 minutes before using to allow for chemical induction. Requires only minimum thinning, is normally ready for application after catalyzation. If thinning is required, use MIL-T-81772B Polyurethane Thinner.