Product Description
A clear or aluminum pigmented phenolic (air dry) varnish for use on ammunition. Class A is Tung oil based, and Class B is Linseed oil based. It is formulated as a low VOC coating, so it meets composition G (general use) and Composition L (low VOC) requirements for VOC’s.
Note: please refer to the appropriate technical performance specification, MIL-V-13750, and applicable technical documents under the MSDS/Documents Tab.
Classification
The varnishes (clear and aluminized) covered by this specification shall be furnished in the following grades:
Grade A – Tung oil para-phenyl phenol-formaldehyde resin varnish.
Grade B – Linseed oil para-phenyl phenol-formaldehyde resin varnish.
Composition
The varnishes covered by this specification shall be of the following compositions:
Composition G – General use
Composition L – Limited use
Also Known As:
» MIL-V-13750
» MIL-V-13750A
» MIL-V-13750B
APPLICATION
Surface must be clean, dry and properly prepared before application. May be applied by brush, roll, dip, or spray.
AEROSOL CANS: Vigorously shake can for one minute to thoroughly mix coating. Shake can occasionally while spraying. Hold can approximately 12″ from surface to be painted.