TT-L-58 Lacquer, Spraying, Clear And Pigmented, For Interior Use

This specification covers clear and pigmented spray lacquers for interior use. The lacquers are furnished in gloss or semi-gloss finishes. This specification is canceled. Superseded by A-A-3003.

SKU: 58. Category: .

Product Description

A very high quality nitrocellulose spray lacquer for general interior use as a finishing coat over a properly prepared primed metal, plastic or sealed wood substrates. It is available in gloss and semigloss sheens, colored and clear spray lacquer options.

Click On The Links Below To View Documents:

Technical Data Sheet (TDS) – TT-L-58E

Surface Preparation:

Surface must be clean, dry and free of all contamination before application of coating. Prime per specification requirements and/or recommendations. STEEL: Surface must be clean and free of all oil, grease and foreign material. Badly rusted or pitted steel should be cleaned by commercial sandblasting and primed the same day. WOOD: Surface must be clean and free of all contaminants. Sand apply a lacquer based sealer before application of topcoat.

Application & Reduction:

TT-L-58E should only be applied by spray application due to its fast dry properties. Thin up to one pint per gallon with MIL-T-81772B Type III Thinner, or as needed for proper atomization with spray equipment. Spray one tack coat followed by one full wet coat being sure to keep a “wet edge” for maximum gloss finish. The use of MIL-C-8514C and TT-P-1757B Primers or other recommended lacquer resistant primers are normally required for use under this lacquer topcoat.

Classifications

Specification

Mil-Spec