A-A-56032 Ink, Marking, Epoxy Base

This commercial item description covers a catalyzed epoxy system of marking inks for metallic or other non-porous surfaces and printed wiring boards.

SKU: 56032. Category: .

Product Description

A two-component, catalyzed epoxy marking ink coating for metallic or other non-porous surfaces and printed wiring boards. A-A-56032D is low VOC and lead and chromate free.

Click On The Links Below To View Documents:

Technical Data Sheet (TDS)- A-A-56032D

Also Known As:

» A-A-56032 TY III
» A-A-56032

SURFACE PREPARATION

Surface must be completely clean, structurally sound, and free of all contaminants (including dirt, wax, loose paint, grease, etc.). Greasy or oily surfaces must be cleaned with solvent with care. Do not paint over moist / wet surfaces.

 

MIXING/APPLICATION INSTRUCTIONS

Each of the two components should be thoroughly mixed separately. Component B is then slowly poured into component A, with constant stirring. The mixing ratio is one to one of each component by volume. Mix thoroughly and allow to induct for one hour before using. Coating is normally ready to use as packaged. If needed, reduce admixed material up to one pint per gallon with MIL-T-81772B Ty.II Thinner. Apply a mist coat and allow to dry to touch (30 Minutes). Apply a second coat to a total dry mil thickness of 1.5 to 1.8 mils. For brushing, us as is after induction time. If higher viscosity is needed, allow a longer induction time, as coating will become thicker with more dwell time.

Clear & All Fed.Std 595 Colors