A-A-2787 Enamel, (Aerosol (Low VOC)

This description covers two types of aerosol enamels meeting National Volatile Organic Compound Emission Standards for Aerosol coatings, 40 CFR 59, Subpart E. The aerosol enamel shall be furnished in nominal 475 mL (1-pint) commercial pressurized dispensers with cover caps protecting the valves. The enamel shall be dispersible by hand shaking for 1 minute at room temperature. The valve shall operate with moderate finger pressure and close immediately upon release of pressure without sputtering. The spray shall be uniform and a smooth film shall be deposited. The can shall deliver a minimum of 98.0 percent by weight of contents.

SKU: 2787. Category: .

Product Description

A-A-2787 TYPE I AEROSOL ENAMEL, LOW VOC is a high quality alkyd enamel available in gloss, semigloss and flat finishes.

Click On The Links Below To View Documents:

Military Performance Specification A-A-2787
Technical Data Sheet (TDS)- A-A-2787 TY I

Surface Preparation:

Surface must be clean, dry and free of all contamination before application. Prime and apply topcoat per specification instructions. If used on previously painted surfaces, coating must be reduced and tested on a small area for compatibility with the existing coating. STEEL: Surface must be clean and free of all oil, grease and foreign material. Badly rusted or pitted steel should be cleaned by commercial sandblasting and primed the same day.

Application & Reduction:

TT-E-527D Enamels can be applied by conventional or airless spray application. For spraying, thin up to 10% or as needed with Xylene. For brushing, use as is or with minimum thinning with TT-T-306C Type I Reducer.