MIL-C-46168 Coating, Aliphatic Polyurethane, Chemical Agent Resistant

This specification covers both camouflage and noncamouflage, chemical agent resistant, aliphatic polyurethane coating for use as a finish coat on military combat equipment. It can be used in areas covered by air pollution regulations. This specification is canceled. Refer to MIL-DTL-53039 or MIL-DTL-64159.

SKU: 46168. Category: .

Product Description

MIL-C-46168D Polyurethane Coating is a two-component chemically cured product that forms a film that is resistant to chemicals, solvents and abrasion. This product has excellent adhesion to most substrates and is recommended for heavy duty industrial applications where a tough, chemical resistant coating is required. This coating is available in a 4:1 mixture for brush, roll and spray applications. It is specially formulated for excellent ultraviolet ray resistance and superior exterior durability. It is low “VOC” and high solids to comply with most regulations. Available in both camouflage and non-camouflage for use as a finish coat of military combat equipment.

Click On The Links Below To View Documents:

Material Safety Data Sheet (MSDS)- MIL-C-46168D Ty. II #16251 Gloss Gray
Material Safety Data Sheet (MSDS)- MIL-C-46168D Ty. II #36118 Flat Gray Polyurethane
Material Safety Data Sheet (MSDS)- MIL-C-46168D Ty. II #36231 Flat Gray Polyurethane
Material Safety Data Sheet (MSDS)- MIL-C-46168D Ty. II #36300 Flat Gray
Material Safety Data Sheet (MSDS)- MIL-C-46168D Ty. II #36320 Flat Gray
Material Safety Data Sheet (MSDS)- MIL-C-46168D Ty. IV #37030 Flat Black
Material Safety Data Sheet (MSDS)- MIL-C-46168D Ty. IV #37038 Flat Black
Material Safety Data Sheet (MSDS)- MIL-C-46168D Ty.II #17038 Gloss Black
Material Safety Data Sheet (MSDS)- MIL-C-46168D Ty.II #27038 SG Black
Technical Data Sheet (TDS)- MIL-C-46168D

Also Known As:

» MIL-C-46168
» QPL-46168

SURFACE PREPARATION

Surface to be coated must be clean, structurally sound and free of all foreign contaminants including dirt, wax, loose paint or grease. Greasy or oily surfaces should be solvent cleaned with care taken not to paint over moist or wet surfaces. The recommended primer is MIL-P-23377F Type I Epoxy Polyamide. The use of alkyd based primers under this coating is not advisable. Old paint in peeling condition must be removed. Sandblasting or wire brushing are the preferred methods. Chalky paint must also be wire brushed for maximum adhesion.

 

APPLICATION

MIL-C-46168D Polyurethane Coating can be brushed rolled or sprayed. Mechanically mix each component, then combine at a ratio of 4:1 by volume. Let admixed material stand for 15 minutes before using to allow for chemical induction. If thinning is required, use MIL-T-81772B Type I Polyurethane Thinner.